Acrylic Copolymer Exterior Flat Paint
DESCRIPTION: This coating is an acrylic copolymer exterior flat paint formulated for new construction and property
maintenance work. This coating has a very flat finish with excellent touch-up qualities, is fast drying, durable wand
has good hide. This coating is recommended for use on stucco, block, masonry and properly and prepared and
SOLVENT TYPE RESIN TYPE
Waterborne Acrylic copolymer
Flat. 1-2% on a 60° meter.
Stock colors: White, Navajo White, Pearl White, Cottage
White, Swiss Coffee, Bone China. Other colors can be special
ordered or store mixed.
Light, medium, ultra deep
VISCOSITY AT 77°F (25°C)
70 g/L (as supplied)
SOLIDS BY VOLUME SOLIDS BY WEIGHT
WEIGHT P GALLON
COMPOSITION BY WEIGHT
Pigment - 38.0% Vehicle - 62.0%
*Prime pigments .......... 15.0 Vinyl acrylic resins...............13.0
Reinforcing pigments ... 23.0 Water & additives................49.0
* Prime pigments include titanium dioxide (TiO2), plus all other
pigments directly adding to the hiding power of this paint.
RECOMMENDED FILM THICKNESS P COAT
Wet: 3.8 mils Dry: 1.5 mils
PRACTICAL COVAGE P COAT AT RECOMMENDED
DRY FILM THICKNESS
0-400 sq. ft. per gallon, depending on surface conditions.
AVAGE DRY TIME AT 77°F (25°C)
To touch: -30 minutes
Tack-free: 30 minutes
Recoat: 1 hour
To handle: 2 hours
Brush, roller, airless spray
One-gallon, five-gallon containers
MATIAL SAFETY DATA SHEET
All surfaces must be cured, clean, dry, and free from dirt, dust,
rust, stains, grease, oil, mildew, wax, efflorescence and other
contaminants. Remove all loose, peeling, or chalky paint by
sanding, scraping, high-pressure washing or other appropriate
methods. Repair all cracks, holes, and other surface
imperfections with a suitable patching material. Repaired
surfaces should match the surrounding surface texture. If
efflorescence exists, remove all noticeable deposits and prime
the entire surface with HJ252 - Waterborne
Epoxy Primer or HJ253 - Acrylic Masonry Sealer.
· If the air or surface temperature is between 37° and 50°F,
add HJ254 - Cold Weather Reducer per label
· Do not apply when the air or surface temperature is below 37°F.
Brush application: Up to 1/2 pint of water per gallon.
Roller application: Up to 1/2 pint of water per gallon.
Spray application: Up to 1 quart of water per gallon.