Epoxy Protective Coating
DESCRIPTION: Feiyang -480 Epoxy Protective Coating is a two-component, high solids epoxy coating. When cured, Feiyang -480 provides a tough, tile-like finish with good flexibility. It protects concrete, steel, or wood against attack by salts, acids and alkalines and some solvents. Feiyang -480 offers excellent corrosion resistance and very good cathodic disbondment resistance. Feiyang -480 can be applied over a wide temperature range and can be heat cured to give high temperature resistance up to 240°. Feiyang -480 complies with all current VOC regulations. PHYSICAL PROPTIES: Color White, Gray Weight per gallon 11.5 lbs Viscosity 5,000 cps Pot Life 4 hours Drying time at 70° F 8 to 12 hours Full Cure 7 days Closed cup flash point Part A 90° F (27° C) Part B 90° F (32° C) Solids by weight 80% Solids by Volume 75% VOC Content 1.11 lb gallon 133 grams per liter Sag Resistance 20 mils Flexibilty, TTP-115 over 1/2 inch mandrel, no peeling or cracking Tensile Strength ASTM D 638 1400 psi SURFACE PREPARATION: On Steel - Prepare in accordance with Steel Structures Painting Council Surface Preparation SSPC-SP10 ""Near-White Metal Blast Cleaning"". All work blasted may be coated the same day with Feiyang -408 Epoxy Zinc Rich Primer. On Concrete - Concrete surfaces should be clean, sound and dry. Abrasive blast to remove dirt, curing compounds, existing coatings or laitance and provide a profile to the concrete. MIXING: Feiyang -480 has a convenient 1:1 mixing ratio by volume and a long pot life to simplify mixing and application. Combine (1) one part by volume of Component ""A"" with (1) one part by volume of Component ""B"". Mix for a minimum of (3) minutes with a low speed electric drill and an Feiyang -Mixing Paddle. No induction time is needed before applying. APPLICATION: Feiyang -480 Epoxy Protective Coating may be applied by brush, roller or spray. All spray equipment must employ traps to prevent water and oil from contaminating coating. Feiyang -480 Epoxy Protective Coating may be applied as high as 20 mils without sagging. COVAGE: Typical application is approximately 200 sq. ft. per gallon. Typical WFT will be eight (8) mils wet to achieve six (6) mils dry. Two coats are recommended. PACKAGING: 2 gallon and 10 gallon units. LIMITATIONS: Shelf Life - unmixed 2 years in closed container. Do not apply below 40° F. CAUTION: ""A"" Component contains epoxy resin. May cause skin sensitization or other allergic responses. Use with good ventilation, particularly if material is heated or sprayed. Prevent all contact with skin or eyes. Wear protective clothing, goggles, gloves and/or barrier creams. Keep container closed when not in use. Wash thoroughly after handling. Flammable DANG! ""B"" Component contains alkaline amines; strong sensitizer. May cause skin sensitization or other allergic responses. Use with good ventilation, particularly if material is heated or sprayed. Prevent all contact with skin or eyes. Wear protective clothing, goggles, gloves and/or barrier creams. Keep container closed when not in use. Wash thoroughly after handling. FIRST AID: In case of skin contact, immediately wash with soap and water. In case of eye contact, flush eyes with copious amounts of water for at least fifteen (15) minutes. Remove contaminated clothing, shoes. If irritation persists, seek medical attention. Wash clothing before reuse.