Nitrocellulose Coatings Supplier in China
Nitrocellulose Coatings paint coating manufacture Shenzhen China  
Home About Us Products Contact Us

 

 




Honest Joy Coating & Paint
Polyurethane Coating

Lacquers for wood
Faux Finishing
Glaze
Nitrocellulose coatings
NC Coatings for furniture
Coatings for picture frames
Non toxic coatings


  

Nitrocellulose Coatings

PRODUCT SPECIFICATIONS:

DESCRIPTION: Hot Spray Lacquer 828 is a resin modified nitrocellulose lacquer designed for
economical finishing of interior timbers by hot spray technique.
FEATURES:  Excellent cold check resistance.
 Excellent flow off the gun.
 May be pulled over to a bright finish.
 Excellent build.
 Good through drying.
 Excellent resistance when stacked to marking.
APPLICATION AREAS: As a finishing coat over previously stained or unstained, filled or sealed interior
surfaces. Typical areas of use are on prefabricated panels, wardrobes and
cupboards, partitions, internal doors, wall units.
TYPICAL SYSTEMS: There are many excellent systems for finishing with Hot Spray Lacquer 828 and the
following are a selection:
Natural Finish Unstained:
i) Apply Sanding Sealer 847, allow to dry a minimum of 1 hour and sand with
320 Frecut paper.
ii) Spray two double header coats and allow to dry 16 hours.
Natural Finish Stained:
i) Stain with Timber Stain 880 and allow to dry 30 minutes.
ii) Apply Sanding Sealer 847, allow to dry a minimum of 1 hour and sand with
320 Frecut Paper.
iii) Spray two double header coats and allow to dry 16 hours.
Full Finish:
i) Fill with an all purpose wood filler of desired colour. Allow to dry a
minimum of 4 hours or force dry.
ii) Apply Sanding Sealer 847, allow to dry a minimum of 1 hour and sand with
320 Frecut paper.
iii) Apply two double header coats and allow to dry 16 hours.

APPLICATION
Conventional Spray By hot spray unit heating
the material to approximately 68oC to 74oC .
Apply at an air atomisng pressure of 350 to 420
kpa. Apply two full coats wet on wet.
THINNING: Thinner 265.
CLEANING: Clean equipment after use with
Thinner 265.
CONTAIN SIZE
4 litre
20 litre
60 litre to order
200 litre to order
PRECAUTIONS
Hot Spray Lacquer 828 contains flammable
solvents. Keep away from heat and open flame.
When applying in a confined space use an air line
respirator. In common with other organic solutions
Hot Spray Lacquer 828 should not be allowed to
remain on the skin and normal hygiene standards
should be observed when using this product.
Spraying should be carried out in an approved
spray booth.
Colours:
Clear
Gloss Levels:
High Gloss
Drying Time:
Dust Free:
Hard Dry:
Print Free:
Hard Dry:
Approximate air drying
times at 25oC
5 - 10 minutes
15 - 20 minutes
1 - 2 hours
16 hours
Can be force dried at 50oC
for 8 hours in a hot room
where the temperature has
been increased to 50oC
over a 1-2 hour period
after lacquered articles
have been placed in the
room.
Recoating Time: With itself after 16 hours.
Shelf Life: 12 months minimum
Flash Point: < 9oC Classification 3.
Setaflash closed cup
method
.
Durability: Excellent interior use
Resistance Properties:
Abrasion:
Heat:
Solvent:
Alcohol:
Perfume:
Water & Steam:
Pressure
Good
Up to 80oC dry heat
Good
Good
Good
Fair
No print marks when
stacking up to at least
37.9kPa after overnight
drying.

 



Contact Us
 
Honest Joy Coating & Paint. All rights reserved.