Pigmented Short Phenolic Modified Alkyd Primer
Description A Pigmented Short Phenolic Modified Alkyd Primer
Basic Use A quick drying lead and chromate free, rust inhibitive primer formulated for priming both interior and exterior iron and steel.
A valuable maintenance primer because of its ability to replace a multitude of primers usually required to insure
compatibility with various topcoats. HJ-800 has good weathering characteristics to protect metal in storage, transit or during
erection. Also exhibits excellent weldable properties.
Colors Red Oxide only
VOC gr/L 554.80 Volume Solids ±2% 31.90 Odor Dominant odor of aromatic
VOC lbs/G 4.63 Weight Solids ±2% 51.40 Thinning None recommended
MPI # Spread Rate 0.0 Weight 9.52
Gloss 60° 60-65 Wet Film Thickness Viscosity 64 to 69 Krebs Units.
Sheen 85° Dry Film Thickness Resistance Excellent
Tinting Type Toxic Properties None as dry film Cleanup Thinner
Local Harvest Light Reflectance Less than 25% Packaging five gallons
pH Pigment Solids Flash Point
HAP Content Pigment Volume H2O Vapor
At 77º Fahrenheit and 50% Relative Humidity.
Dry To Touch 10 to 15 minutes Dry To Sand Tack Free
Dry To Recoat 1 hour Dry To Topcoat Dry To Hard
Prep & Prime
Surfaces must be clean, dry, and free of contaminants such as wax, oils, grease, weld splatter, loose mil, scale, rust. As a minimum
SSPC-SPC Hand Tool Cleaning or SSPC-SPC3 Machine Tool Cleaning is recommended for interior exposure. Smooth surfaces should be
abraded to enhance adhesion. Improved performance can be achieved with and SSPC-SPC6 Commercial Blast. All surfaces prepared for
painting should be coated within 8 hours of completion of surface prep.
Metal Ferrous Metal: Can be applied directly to clean, dry, ferrous metal. Galvanized Metal: Clean thoroughly.