Rapid Drying Copolymer Enamel
A very fast air dry enamel based on modified co-polymer resins.
As a finishing coat over a wide range of anti-corrosive primers or and primer surfacers. Features
_ Exceptionally fast drying
_ Excellent spraying characteristics
_ Good wrinkling resistance in thick films
_ One coat finish for economical work
As a finishing coat over a range of primers or undercoats. Typical areas of use are on sheet metal,
agricultural implements, cabinets, engines, chassis, furniture and switchboards.
Systems Substrate Surface Preparation Typical Systems dft mm
Abrasive blast clean to AS 1627.4
1st Coat: HJ-76
Remove rust, clean and degrease.
1st Coat: HJ-69
Solvent degrease and abrade and
clean. Sweep blasting
recommended for larger sections.
1st Coat: HJ-002
2nd Coat: HJ-76
Weathering Moderate exterior durability
Finish High gloss, reduced gloss levels available on request.
Chemical Resistance Not recommended.
Abrasion Resistance Moderate
Immersion Not normally recommended
Temperature Range Up to 1oC dry heat.
Colour Most Standard Colours available.
Topcoating Not normally topcoated
Shelf Life 12 months from date of shipment if stored indoors at 4°C to 38°C.
Theoretical Coverage 9.1 Sq Metres per litre at 40 mm dry film thickness. (Wet film thickness 100 μm).
Volume Solids 39%
(@ 25ºC, 50% R.H.)
Dust free: 3 Minutes; Touch Dry: 15 Minutes; Print free: 45 Minutes; Hard dry: 12-16
Hours. Recoating time: Up to 4 Hrs. Not recommended outside this period.