quality coarse-textured coating
SOLVENT TYPE RESIN TYPE
Waterborne Acrylic copolymer
FINISH (ASTM D 523)
Flat. Coarse texture.
Stock colors: White. Other light and medium colors can be special ordered.
VISCOSITY AT 77°F/25°C (ASTM D 562)
MAXIMUM VOC CONTENT
60 g/L (as supplied)
SOLIDS BY VOLUME (ASTM D 2697) SOLIDS BY WEIGHT
50.0% ± 2% 59.0% ± 2%
WEIGHT P GALLON (ASTM D 1475)
COMPOSITION BY WEIGHT
Pigment - 36.0% Vehicle - 64.0%
*Prime pigments ......................7.0 Vinyl acrylic resins ......................... 21.0
Reinforcing pigments .............29.0 Water & additives........................... 43.0
*Prime pigments include titanium dioxide (TiO2), plus all other pigments
directly adding to the hiding power of this paint.
RECOMMENDED FILM THICKNESS P COAT
Wet: 29.0 mils Dry: 14.0 mils
PRACTICAL COVAGE P COAT AT RECOMMENDED DRY FILM
40-50 sq. ft. per gallon, depending on surface conditions.
AVAGE DRY TIME AT 77°F/25°C (ASTM D 1640)
To touch: 1-2 hours
Recoat: 4-6 hours
All surfaces must be cured, clean, dry, and free from dirt, dust, rust, stains,
grease, oil, mildew, wax, efflorescence and other contaminants. Remove all
loose, peeling, or chalky paint by sanding, scraping, wire brushing,
sandblasting, high-pressure washing or other appropriate methods.
hairline cracks with an elastomeric patching material and repair expansion
joints with Honest ’ . Repaired surfaces should match the
surrounding surface texture. If efflorescence exists, remove all noticeable
deposits and prime the entire surface with Honest-W8810 -
Waterborne Epoxy Primer or Honest-8801 - Acrylic Masonry Sealer.
• CAUTION: Scraping or sanding surfaces of older buildings may release dust containing lead or asbestos. EXPOSURE TO
LEAD OR ASBESTOS CAN BE VY HAZARDOUS TO YOUR HEALTH.
Always wear appropriate personal protective equipment during surface
preparation, and finish cleanup of any residues by water-washing all
• This product can neither cause nor prevent or cure the growth of mold,
mildew, or other forms of fungus. Excessive moisture and inadequate
ventilation are the main conditions that promote their growth. Correct any
such conditions before painting.
• Do not apply when the air or surface temperature is below 50°F.
Do not thin.
Store in a dry area. Protect from freezing. Extreme temperatures may cause
paint to become unusable. For example: Freezing and thawing may cause
paint to gel, and high heat may cause a solid skin to form.
Warm, soapy water