Quality Fine-textured Coating Supplier in China
Quality Fine-textured Coating paint coating manufacture Shenzhen China  
Home About Us Products Contact Us

 

 




Honest Joy Coating & Paint
Texture coating
Quality Coarse-textured Coating
Quality Fine-textured Coating
vvv Textured Finish
Medium Fine Textured coating
Polyurethane Textured Topcoat
Epoxy polyamide texture Coating
Marble Finish
Rubber Soft Touch coating textured coating
Fibered White Elastomeric Coating

  

quality fine-textured coating

PRODUCT INFORMATION
SOLVENT TYPE RESIN TYPE
Waterborne Acrylic copolymer
FINISH (ASTM D 523)
Flat. Fine texture.
COLORS
Stock colors: White. Other light and medium colors can be special ordered.
TINT BASES
Not Available
VISCOSITY AT 77°F/25°C (ASTM D 562)
121-125 KU
MAXIMUM VOC CONTENT
50 g/L (as supplied)
SOLIDS BY VOLUME (ASTM D 2697) SOLIDS BY WEIGHT
49.0% ± 2% 63.0% ± 2%
WEIGHT P GALLON (ASTM D 1475)
11.80 lbs.
COMPOSITION BY WEIGHT
Pigment - 41.0% Vehicle - 59.0%
*Prime pigments ......................6.0 Vinyl acrylic resins ......................... 21.0
Reinforcing pigments .............35.0 Water & additives........................... 38.0
*Prime pigments include titanium dioxide (TiO2), plus all other pigments
directly adding to the hiding power of this paint.
RECOMMENDED FILM THICKNESS P COAT
Wet: 29.0 mils Dry: 14.0 mils
PRACTICAL COVAGE P COAT AT RECOMMENDED DRY FILM
THICKNESS
40-50 sq. ft. per gallon, depending on surface conditions.
AVAGE DRY TIME AT 77°F/25°C (ASTM D 1640)
To touch: 1-2 hours
Recoat: 4-6 hours

PACKAGING
Five-gallon containers
:

MATIAL SAFETY DATA SHEET
SURFACE PREPARATION
All surfaces must be cured, clean, dry, and free from dirt, dust, rust, stains,
grease, oil, mildew, wax, efflorescence and other contaminants. Remove all
loose, peeling, or chalky paint by sanding, scraping, wire brushing,
sandblasting, high-pressure washing or other appropriate methods.

SPECIAL INSTRUCTIONS
• CAUTION: Scraping or sanding surfaces of older buildings (especially pre-
1978) may release dust containing lead or asbestos. EXPOSURE TO
LEAD OR ASBESTOS CAN BE VY HAZARDOUS TO YOUR HEALTH.
Always wear appropriate personal protective equipment during surface
preparation, and finish cleanup of any residues by water-washing all
surfaces. ”


• This product can neither cause nor prevent or cure the growth of mold,
mildew, or other forms of fungus. Excessive moisture and inadequate
ventilation are the main conditions that promote their growth. Correct any
such conditions before painting.
• Do not apply when the air or surface temperature is below 50°F.
THINNING RECOMMENDATIONS
Do not thin.
STORAGE
Store in a dry area. Protect from freezing. Extreme temperatures may cause
paint to become unusable. For example: Freezing and thawing may cause
paint to gel, and high heat may cause a solid skin to form.
CLEANUP
Warm, soapy water

 



Contact Us
 
Honest Joy Coating & Paint. All rights reserved.